一、General picture：
The components of AP&T®
are as the right picture:
1.Sensor- Transmitter 5
2.Signal Receiver/Board 1
3.Battery of Li(900mA) 1
4.Charger 1
5.User munual 1
6.Certificate of quality 1
7.Service card 1
1.Operation principle
This device does not have the
blind spot to monitor the scheme to adopt in succession，it can monitor
the pressure and temperature of the tire every minute.When the pressure
of the tire is lower than the warning pressure, higher than the warning
pressure or higher than warning temperature,the transmitter will send
out the alarm signal ，and when the signal Receivers receive signals ,the
Signal Board will get red background light glimmer , pronunciation "
please slow down, park aside, check the tire " .At that moment,the
liquid crystal display will show you the number of tire and the classification
of alarm（for example:02HP高压、03LP低压or01HT高温），then you can avoid the accident
and be sure of you safety.
2.The method of supply power
The Sensor- Transmitter have already
installed the long result battery which has passed special-purpose processing
before dispatched from the factory.The battery can use for more than 2
years in succession,and if it has trouble,please
check or change the battery .
The Sensor- Transmitter has three method
of supply power：①for the Small-scale
automobile:Supplied power by the built-in lithium battery，supply power
or charge (12V ) with the special-purpose charger (12V)；②for the Passenger
train and cargo truck:Supplied power directly by the battery wiring of
12~24V.
★★★Using the lithium battery for the first time,
please use the charger of battery of mobile phone (2110 or 3210 models
of Nokia ) to supply power for 126 hours in succession.
3.The use of Signal Receiver/Board
| （1）System operate normally, instruct that glimmers , show the temperature in train meanwhile (such as 28??C) ，The other lights can not be pointed out ；
|
（2）When the
voltage is lower than the specified parameter , charge and point
out that glimmers，voice prompt: " please show to receiving
the device is charged ".Show charging while charging.When the
voltage of the battery is up to 4.2 V, charge and point out that
disappears to resume the normal condition
|
| （3）After the pressure
of the tire is lower than a certain specified parameter，the Signal
Board will get red background light glimmer , pronunciation "
please slow down, park aside, check the tire " .At that moment,the
liquid crystal display will show you the number of tire and the
classification of alarm，for example“01LP低压”means the pressure of
No.1 tire has get low.At that time,you should slow down, park aside,and
check the tire
|
（4）If it shows“01HP高压”，means the pressure of No.1 tire has get high，Signal Board will get red background light glimmer , pronunciation " please slow down, park aside, check the tire " .
|
| （5）If it shows“01HT高温”means
the tempeture of No.1 tire has get high，Signal Board will get red
background light glimmer , pronunciation " please slow down,
park aside, check the tire " .
|
★★★Corresponding position of the tire number:
|
（6） CQ—Z/P— XX —X For the for the Small-scale automobile ，The main
type is: |
|
